ISO 6452 Automotive Interior: Fogging (accredited)

Testing acc. to ISO 6452: Rubber- or plastics-coated fabrics — Determination of fogging characteristics of trim materials in the interior of automobiles

Our test laboratory performs testing according to ISO 6452 using an accredited reflectometric method to determine the fogging characteristics of materials used in vehicle interiors. Under defined thermal conditions, the test examines the extent to which volatile constituents are released from a material and subsequently condense on a cooler surface. Reflectometric measurement evaluates the change in the gloss value of a glass plate caused by the deposited condensate.

The method is particularly intended for rubber- or plastics-coated fabrics and other materials used in vehicle interiors. Typical materials include synthetic leather, plastics, elastomers, films, foams, coatings and composites. At elevated temperatures, volatile constituents may be released from these materials and deposited on the inside of vehicle windows, potentially impairing visibility. The test provides important parameters for assessing fogging behaviour and supporting quality assurance of automotive interior materials.

Test Procedure According to ISO 6452

During fogging testing, a prepared specimen is heated in a temperature-controlled test vessel. The released volatile constituents condense on a cooled glass plate. Testing is carried out under defined temperature and time conditions, typically with the specimen heated to 100 °C and the condensation surface cooled to approximately 21 °C.

The reflectometric method measures the gloss value of the glass plate before and after fogging exposure. The fogging value F is calculated as a percentage from the ratio of the measured values. For valid measurements, a higher value indicates less optical impairment caused by the condensate.

The standard additionally describes a gravimetric method in which the mass of constituents condensed on a cooled aluminium foil is determined and expressed in milligrams. This method is particularly suitable when transparent condensate films are formed that cannot be reliably evaluated by reflectometric measurements. The two methods assess different characteristics and their results are not directly interchangeable.

Applications of the Test

Testing according to ISO 6452 enables a comparative assessment of the fogging characteristics of different materials and material combinations. Differences in polymer composition, plasticisers, additives, coatings and manufacturing processes can influence the release of condensable constituents and can be characterised by this test.

Typical applications include synthetic leather and coated textiles used for automotive seats, dashboard coverings, door panels and other interior trim components. The results support material selection, product development, incoming goods inspection and quality assurance. Fogging investigations are particularly important for the development of low-emission interior materials and the verification of automotive manufacturer specifications.

The test evaluates the condensation behaviour of volatile constituents under defined conditions. However, it does not identify individual emitted substances or provide a comprehensive assessment of vehicle interior air quality. Additional emission analysis may therefore be required for more detailed investigations.

Related Tests

For investigating the fogging characteristics of different automotive interior materials, FILK also offers accredited testing according to DIN 75201. This standard includes different procedures for gravimetric, reflectometric and optical evaluation of fogging deposits.

For leather used in vehicle interiors, FILK offers accredited testing according to DIN EN ISO 17071. This method takes into account the specific properties of leather and includes both reflectometric and gravimetric procedures. Accredited testing according to VW PV 3015 is also available for the gravimetric determination of condensable constituents in accordance with Volkswagen specifications. Further testing methods are summarised in the Fogging section.

Further information on our testing methods for volatile and condensable constituents is available in our Emissions and Odour Testing overview. A comprehensive overview of our testing services is provided in the Accredited Test Laboratory overview.



Inquiry to Test Laboratory

Contact

FILK Freiberg Institute gGmbH
Meißner Ring 1-5
09599 Freiberg

GERMANY

Fon: +49-(0)3731-366-0
Fax: +49-(0)3731-366-130
E-Mail: mailbox@filkfreiberg.de